Our Blog


Rena Imager XT 3.0 printer problem with head height bouncing up and down when adjusting head height

Problem: We have a Rena Imager XT 3.0 that is having problems with the head height. Instead of going right to the height you set when going to print it bounces up and down, sometimes it will settle down to the correct height, but usually, I have to push on the gear. I’ve seen a […]

Read Full Post

Do you offer Leasing or Financing?

We’re often asked if we offer leasing or financing. Yes, we do! For leasing, we’ve teamed with a company that knows and understands the addressing industry and the equipment. With a better understanding of the industry, they are often able to get the job done when others can’t! To get an idea of how much […]

Read Full Post

How do I adjust and clean the Accufast KT Tab Sensor?

UPDATED 12/19/2018 If you experience tabbing problems on the Accufast KT, tune the sensor for clear tabs – translucent tabs Also know as a KT Sensor Reset: WARNING DO NOT PLACE FINGERS OR TOOLS BETWEENOR NEAR MOVING PARTS. 1) Turn the POWER SWITCH off.2) Remove any tabs and debris from the peel point area through the […]

Read Full Post

Where can I download a Operators Manual for my Accufast KT Tabber and XL Labeler

? I just purchased a used Accufast XL labeler and KT Tabber. But they came without manuals. Were can I get manuals for them? Answer:  SuppliesForMailers.com For the Accufast XL Operators Instruction Manual go here.  http://suppliesformailers.com/xl-operators-manual-instruction.aspx For the Accufast KT Operators Instruction Manual go here.   http://suppliesformailers.com/accufast-kt-operators-manual.aspx While you are there.. Need tabs – wafer seals made to […]

Read Full Post

Cleaning and Maintaining HP C8842A and other TIJ 2.5 Cartridges

Updated 5/14/2020 The most common problem we have with address printers is poor print quality!  This comes from people not understanding proper cleaning and handling of HP TIJ 2.5 cartridges like HP C8842A and SFM 42A. None of the printers in the industry do a good job of properly cleaning and capping the cartridge.  Some […]

Read Full Post

Bryce 30K manual – print head problem.

Question: I purchased a used 30K and it did not come with a manual. Recently the red LEDs on two of the print heads have come on. One is continuous and the other is blinkiing. Without a manual I have no idea what this means. Can anyone point me to an online manual or tell […]

Read Full Post